Dell PowerEdge R730 Owner's Manual

Installing the cable retention bracket

Prerequisites

Follow the safety guidelines listed in the Safety instructions section.
Follow the procedure listed in the Before working inside your system section.
If installed, remove the cooling shroud.
Remove the PCIe card holder.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

Align the cable retention bracket with the alignment pins on the chassis.
Slide the cable retention bracket along the chassis wall until the tab clicks and locks the keyhole slots.
Place all cables to be routed in the cable retention bracket.
Figure 1. Installing the cable retention bracket
1. alignment pin (2)
2. keyhole slot
3. tab
4. cable retention bracket

Next steps

Install the PCIe card holder.
Install the cooling shroud.
Follow the procedure listed in the After working inside your system section.

Velkommen

Velkommen hos Dell

Dell PowerEdge R730 Owner's Manual

Installing the cable retention bracket

Prerequisites

Steps

Next steps

Bedøm indholdet