By default, PowerSwitches boot in Full Switch mode when you power them up with SmartFabric OS10. This information explains how to setup a fabric.
Enable SFS and set roles on the switches.
Connect to SFS GUI and complete the relevant fabric configurations to setup the fabric. See
SFS GUI for more information regarding login procedure and fabric configurations.
For SFS with Isilon/PowerScale deployment, you only have to enable SFS with roles on all the switches using CLI. All other SFS initial deployment operations using UI are not required. For more information regarding PowerScale deployments, see the related documents available in
PowerScale Info Hubs.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\