- Notes, cautions, and warnings
- About this guide
- Change history
- SFS fundamentals
- Setting up SFS
- Managing SmartFabric with the SFS GUI
- Access fabric setup options
- SmartFabric overview
- View fabric topology
- Manage switches in a fabric
- Configure server interface profile
- Configure and manage uplinks
- Configure networks and routing configuration
- Configure global settings for SmartFabric
- Restore fabric configuration
- View fabric compliance status
- Access fabric setup options
- SFS with VxRail
- SFS with PowerEdge MX
- SFS for Isilon/PowerScale back-end fabric
- SmartFabric commands
- smartfabric l3fabric enable
- show logging smartfabric
- show smartfabric cluster
- show smartfabric cluster member
- show smartfabric configured-server
- show smartfabric configured-server configured-server-interface
- show smartfabric details
- show smartfabric discovered-server
- show smartfabric discovered-server discovered-server-interface
- show smartfabric networks
- show smartfabric nodes
- show smartfabric personality
- show smartfabric uplinks
- show smartfabric upgrade-status
- show smartfabric validation-errors
- show switch-operating-mode
- Best Practices
- Appendix
Dell SmartFabric Services User Guide Release 10.5.3
Verify the switch operating mode
To verify that the switches are in SmartFabric mode, run the show switch-operating-mode command on each switch.
OS10# show switch-operating-mode Switch-Operating-Mode : SmartFabric Mode
For more information regarding the CLI, see the show switch-operating-mode command.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\