Create, edit, and delete L2 and L3 profile VXLAN network configurations through SFS GUI. The purpose of VXLAN network is to associate multiple L2 or L3 VLAN networks to a single VXLAN network. Whereas a general purpose network does not have the flexibility to extend the VXLAN network.
Create VxLAN network
Virtual network for L2 profile:
Click
Network.
Select
Networks >
VxLAN Networks. The page displays the list of the VXLAN networks that are configured in the SmartFabric instance.
Click
Create.
Select
Layer 2 as the virtual network type.
Enter the following details:
Virtual network name
VxLAN VNI
VLT VLAN ID
(Optional) Description
Click
Create.
The system displays virtual network creation successful message.
Virtual network for L3 profile:
From OS10.5.3.0 release, you can configure the IPv6 virtual networks. From OS10.5.4.0 release, you can associate the tenant network to the IPv4 L3 virtual network.
Select
Networks >
VxLAN Networks. The page displays the list of the VXLAN networks that are configured in the SmartFabric instance.
Click
Create.
Select
Layer 3 as the
Virtual Network Type.
Enter the following:
Virtual network name
VxLAN VNI
VLT VLAN ID
Select the Tenant network from the list.
NOTE Tenant network is not supported for IPv6 virtual network.
Select IPv4 checkbox to provide the IPv4 address, prefix, gateway IP address, and helper addresses.
Select IPv6 checkbox to provide the IPv6 address, prefix, gateway IP address, and helper addresses.
Click
Create.
View VxLAN network details
The VxLAN networks display a list of mapped VLANs. Select a VxLAN network to view details pertaining to that specific network including network ID, VLAN ID, and network name.
Associate multiple VLANs to a VxLAN network
Using the following steps, you can map multiple VLANs to a single VxLAN network:
Select a VxLAN network.
Click
Create option available after the VxLAN details.
Enter the required details for the VLAN configuration.
Click
Create.
Edit VxLAN network
You can edit the configuration of VXLAN network configuration. You can also change the network type such as from L2 to L3 or L3 to L2.
Select a virtual network from the list and click
Edit.
Modify the network type.
Enter the relevant details.
Click
Edit.
The system displays virtual network edits success message.
Delete VxLAN network
To delete a VXLAN network, first delete the mapped VLAN or VLANs if associated, and delete the virtual network.
Select the Virtual Network Name, select the Network to remove, then click
Delete.
Click
Delete to confirm.
The system displays network deletion success message.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\