- Notes, cautions, and warnings
- About this guide
- Change history
- SFS fundamentals
- Setting up SFS
- Managing SmartFabric with the SFS GUI
- Access fabric setup options
- SmartFabric overview
- View fabric topology
- Manage switches in a fabric
- Configure server interface profile
- Configure and manage uplinks
- Configure networks and routing configuration
- Configure global settings for SmartFabric
- Restore fabric configuration
- View fabric compliance status
- Access fabric setup options
- SFS with VxRail
- SFS with PowerEdge MX
- SFS for Isilon/PowerScale back-end fabric
- SmartFabric commands
- smartfabric l3fabric enable
- show logging smartfabric
- show smartfabric cluster
- show smartfabric cluster member
- show smartfabric configured-server
- show smartfabric configured-server configured-server-interface
- show smartfabric details
- show smartfabric discovered-server
- show smartfabric discovered-server discovered-server-interface
- show smartfabric networks
- show smartfabric nodes
- show smartfabric personality
- show smartfabric uplinks
- show smartfabric upgrade-status
- show smartfabric validation-errors
- show switch-operating-mode
- Best Practices
- Appendix
Dell SmartFabric Services User Guide Release 10.5.3
Supported switches
The following PowerSwitches are supported in PowerScale deployment:
- S4112F-ON
- S4148F-ON
- S5232F-ON
- Z9264F-ON
- Z9100-ON
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\