- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Network Attached Storage Overview
- Managing Assets and Protection
- About NAS protection
- Enable the NAS asset source
- Add a NAS appliance
- Add a NAS share
- Edit or delete a NAS asset source
- Deploy a protection engine for NAS asset protection
- Add a centralized protection policy for NAS assets
- Restore a NAS asset to the original location
- Restore a NAS asset to an alternate location
- NAS file level restore using File Search
- Protection engine parameters
- Determine protection engine usage for a protection job
- Change the protection engine Docker network range
- Troubleshooting
PowerProtect Data Manager 19.9 Network Attached Storage User Guide
Roadmap for NAS protection
Complete the following objectives to protect NAS assets.
Steps
-
Review the NAS protection prerequisites and complete the initial configuration.
Prerequisites and Limitations provides more information.
-
Enable the NAS asset source.
Enable the NAS asset source provides instructions.
-
Add a NAS appliance or share.
Add a NAS appliance and Add a NAS share provide instructions.
-
Deploy at least one
protection engine.
Deploy a protection engine for NAS asset protection provides instructions.
-
Configure a protection policy for NAS assets.
Add a centralized protection policy for NAS assets provides instructions.
-
If required, perform a manual backup with the NAS protection policy.
The PowerProtect Data Manager Administration and User Guide provides more information. Alternatively, protection starts according to the specified schedule.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\