- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Real-Time Clock (RTC Reset)
- Recovering the operating system
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
XPS 17 9720 Service Manual
Installing the audio daughter-board
Prerequisites
About this task
The following image indicates the location of the audio daughter-board and provides a visual representation of the installation procedure.
Steps
- Align the screw hole on the audio daughter-board with the screw hole on the palm-rest and keyboard assembly.
- Replace the three (M2x4) screws that secure the audio daughter-board to the palm-rest and keyboard assembly.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\