- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Real-Time Clock (RTC Reset)
- Recovering the operating system
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
XPS 17 9720 Service Manual
Removing the display assembly
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- Remove the two (M2x4) screws that secure the display-cable bracket to the system board.
- Lift the display-cable bracket off the system board.
- Disconnect the camera connector and the display connector from the system board.
- Remove the three (M2.5x6) screws that secure the left display hinge to the palm-rest and keyboard assembly.
- Remove the three (M2.5x6) screws that secure the right display hinge to the palm-rest and keyboard assembly.
- Push the left and the right hinges back to free them from the palm-rest and keyboard assembly.
- Slide the palm-rest and keyboard assembly from the display assembly.
- After performing all the above steps, you are left with the display assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\