- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Real-Time Clock (RTC Reset)
- Recovering the operating system
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
XPS 17 9720 Service Manual
Installing the memory module
Prerequisites
About this task
The following image indicates the location of the memory modules and provides a visual representation of the installation procedure.
Steps
- Lift the Mylar that covers the memory-module slot.
- Align the notch on the memory module with the tab on the memory-module slot.
- Slide the memory module firmly at an angle, into the memory-module slot.
- Press the memory module down until it clicks into place.
NOTE:If you do not hear the click, remove the memory module and reinstall it.NOTE:Repeat step 1 to step 4 to remove any other memory modules installed in your computer.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\