- Notes, cautions, and warnings
- Copyright
- Before working inside your computer
- After working inside your computer
- Technical overview
- Removing the stability foot
- Replacing the stability foot
- Removing the left-side cover
- Replacing the left-side cover
- Removing the right-side cover
- Replacing the right-side cover
- Removing the top-cover assembly
- Replacing the top-cover assembly
- Removing the bottom cover
- Replacing the bottom cover
- Removing the 3.5-inch hard drive
- Replacing the 3.5-inch hard drive
- Removing the 2.5-inch hard drive
- Replacing the 2.5-inch hard drive
- Removing the U.2 solid-state drive
- Replacing the U.2 solid-state drive
- Removing the hard-drive cage
- Replacing the hard-drive cage
- Removing the power-supply unit
- Replacing the power-supply unit
- Removing the processor-cooling assembly
- Replacing the processor-cooling assembly
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the memory modules
- Replacing the memory modules
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the graphics card
- Replacing the graphics card
- Removing the VR heat sink
- Replacing the VR heat sink
- Removing the processor fan and heat-sink assembly
- Replacing the processor fan and heat-sink assembly
- Removing the processor
- Replacing the processor
- Removing the wireless card
- Replacing the wireless card
- Removing the antenna
- Replacing the antenna
- Removing the front-chassis fan
- Replacing the front-chassis fan
- Removing the top-chassis fan
- Replacing the top-chassis fan
- Removing the optical drive
- Replacing the optical drive
- Removing the front bezel
- Replacing the front bezel
- Removing the power-button board
- Replacing the power-button board
- Removing the rear trim cover
- Replacing the rear trim cover
- Removing the system board
- Replacing the system board
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Aurora R7 Service Manual
BIOS Features
-
USB 2.0/3.1 Gen 1/3.1 Gen 2 Support
-
Wake on USB scan-code from S4/S5 - All USB ports
-
Support Wake-on-LAN (WOL) from S3/S4 for on-board network access.
-
Support for utility partition.
-
UEFI BIOS SUPPORT to ASSURE Win10 Logo Compliance
-
Ability to detect connected display and show POST information on that display
-
HW Monitoring Readouts for voltages and support for 3rd Party applications to detect voltages
-
iRST support
-
Boot from the NVMe SSD support
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\