Aurora R7 Service Manual

Procedure

Slide the radiator and fan assembly into the radiator and fan cage.
Align the screw holes on the radiator and fan assembly with the screw holes on the radiator and fan cage.
Replace the screws that secure the radiator and fan assembly to the radiator and fan cage.
Align the screw holes on the processor cooler with the screw holes on the system board.
In sequential order (indicated on the processor cooler), tighten the captive screws that secure the processor cooler to the system board.
- NOTE: If your are using an electric screwdriver, torque the screws at 6.9 +/-1.15 kilogram-force centimeter (6 +/-1 pound force inch).
Connect the processor-cooling assembly cables to the system board.
Figure 1. Replacing the processor-cooling assembly
1. radiator fan
2. radiator-fan cable
3. processor-cooling assembly cable
4. system board
5. captive screws (4)
6. processor-cooling assembly
Align the screw holes on the VR heat sink with the screw holes on the system board.
Tighten the captive screws that secure the VR heat sink to the system board.
Figure 2. Replacing the VR heat sink
1. VR heat sink
2. captive screws (2)
Follow the procedure from step 10 to step 11 in " Replacing the power-supply unit ".
Replace the screws that secure the radiator and fan assembly to the chassis.