Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Edge Gateway5000 Series Installation and Operation Manual

PDF

Common port mappings

Serial Port Mapping

The table show the serial port mapping on the Edge Gateway 5000/5100 with factory installed Windows 10 IoT Enterprise LTSB 2015. For dip switch setting on the Edge Gateway for RS422 and RS485 ports, see DIP Switches.

No.

Port Type

Connector

Device Node

1

RS232

DB9

COM1

2

RS422_485

5 pin terminal

COM2

3

RS485

3 pin terminal

COM3

4

RS485

3 pin terminal

COM4

Edge Gateway I/O Module GPIO Mapping

The GPIOs on the external I/O Module for the Edge Gateway are behind PIC microcontroller. The PIC microcontroller is exposed to the host system and to the host OS as a USB-HID device. Software applications developed to communicate with the GPIOs may use the protocol defined in the following set of references to communicate with the GPIO modules.

Edge Gateway I/O Module PCIe expansion mapping

The PCIe slot on the external I/O module for the Edge Gateway are driven directly from the host PCIe bus. Since it is generic PCIe expansion there are no PCIe device specific drivers integrated into the Windows 10 IoT Enterprise LTSB 2015 OS image. If there are specific PCIe card used on this slot, contact the vendor of that PCIe card to verify if they have Windows 10 IoT Enterprise LTSB 2015 drivers.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\