Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Edge Gateway5000 Series Installation and Operation Manual

PDF

Setting up the enclosure

  1. Install the enclosure’s wall-mount bracket at a desired location and secure it to the wall using the wall-mount screws.
    • NOTE: Ensure that the notch on the bracket is on the top.
    • NOTE: The wall-mount screws are not included with the enclosure.
    Image: Installing the wall bracket
  2. Open the enclosure.
    Image: Open the enclosure
  3. Place the enclosure on the wall-mount bracket, and align the tab on the back of the enclosure so that it fits into the notch on the wall bracket.
    Image: Mount the enclosure
  4. Secure the enclosure to the wall bracket by using the rubber washers and screws.
    Image: Secure the enclosure
  5. Secure the enclosure mounting brackets to the Edge Gateway by using the screws.
    • NOTE: Before attaching the brackets to the Edge Gateway, note the correct orientation of the brackets.
    Image: Secure the brackets to the Edge Gateway
  6. Position the Edge Gateway onto the enclosure’s two locator pins, and then place and tighten the screws to secure the Edge Gateway to the enclosure.
    Image: Secure the Edge Gateway to the enclosure
  7. Connect the intrusion switch to the system.
    Image: Install the intrusion switch
  8. Remove the desired conduit plugs on the bottom or the left side of the enclosure and install the wiring conduits.
    • NOTE: To ensure that dust and water does not enter the enclosure, install a conduit rated as IP65.
    Image: Install the IP65 conduits
  9. Route the cables through the conduits and connect the cables to the desired connectors.
    • NOTE: To reduce the risk of accidental cable disconnection, tie all cables to the cable tie-off guides.
    Image: Route the cables
  10. Close and securely latch the enclosure door.
    Image: Close the enclosure

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\