Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

privilege level (CONFIGURATION mode)

Change the access or privilege level of one or more commands.

Syntax

privilege mode {level level command | reset command}

To delete access to a level and command, use the no privilege mode level level command command.

Parameters

mode	Enter one of the following keywords as the mode for which you are controlling access: `configure` for CONFIGURATION mode `exec` for EXEC mode `interface` for INTERFACE modes `line` for LINE mode `route-map` for ROUTE-MAP mode `router` for ROUTER OSPF, ROUTER RIP, ROUTER ISIS and ROUTER BGP modes
level level	Enter the keyword `level` then a number for the access level. The range is from 0 to 15. Level 1 is EXEC mode and Level 15 allows access to all CLI modes and commands.
reset	Enter the keyword `reset` to return the security level to the default setting.
command	Enter the command’s keywords to assign the command to a certain access level. You can enter one or all of the keywords.

Defaults

Not configured.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

To define a password for the level to which you are assigning privilege or access, use the enable password command.