Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show isis protocol

Display IS-IS routing information.

Syntax

show isis protocol

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Example

The bold section identifies that Multi-Topology IS-IS is enabled.

Dell#show isis protocol
                                             IS-IS Router: <Null Tag>
                                             System Id: F100.E120.0013 IS-Type: level-1-2
                                             Manual area address(es):
                                             49.0000.0001
                                             Routing for area address(es):
                                             49.0000.0001
                                             Interfaces supported by IS-IS:
                                             GigabitEthernet 1/0 - IP - IPv6
                                             GigabitEthernet 1/1 - IP - IPv6
                                             GigabitEthernet 1/10 - IP - IPv6
                                             Loopback 0 - IP - IPv6
                                             Redistributing:
                                             Distance: 115
                                             Generate narrow metrics: level-1-2
                                             Accept narrow metrics:   level-1-2
                                             Generate wide metrics:   none
                                             Accept wide metrics:     none
                                             
                                             Multi Topology Routing is enabled in transition mode.
                                             Dell#