Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

vlan max-age

To maintain configuration information before refreshing that information, set the time interval for the PVST+ bridge.

Syntax

vlan vlan-range max-age seconds

To return to the default, use the no vlan max-age command.

Parameters

vlan vlan-range	Enter the keyword `vlan` then the VLAN numbers. The range is from 1 to 4094.
max-age seconds	Enter the keywords `max-age` then the time interval, in seconds, that the system waits before refreshing configuration information. The range is from 6 to 40 seconds. The default is 20 seconds.

Defaults

20 seconds

Command Modes

CONFIGURATION (conf-pvst)

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Related Commands

vlan bridge-priority — sets the bridge-priority value.

vlan forward-delay — changes the time interval before the system transitions to the forwarding state.

vlan hello-time — changes the time interval between BPDUs.

show spanning-tree pvst — displays the PVST+ configuration.