- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended Tools
- Removing the Base Cover
- Installing the Base Cover
- Removing the Battery
- Installing the Battery
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Solid-State Drive (half-length)
- Installing the Solid-State Drive (half-length)
- Removing the Solid-State Drive (full-length)
- Installing the Solid-State Drive (full-length)
- Removing the Speakers
- Installing the Speakers
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the Fans
- Installing the Fans
- Removing the Heatsink
- Installing the Heatsink
- Removing the Memory Module(s)
- Installing the Memory Module(s)
- Removing the System Board
- Installing the System Board
- Removing the Audio Daughter Board
- Installing the audio daughter board
- Removing the Keyboard
- Installing the Keyboard
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the DC-in Connector
- Installing the DC-in Adapter Port
- Removing the antenna cover
- Installing the antenna cover
- Removing the display hinges
- Installing the display hinges
- Removing the antenna module
- Installing the antenna module
- Removing the palm-rest assembly
- Installing the palm-rest assembly
- BIOS setup
- Troubleshooting
- Diagnostics
- Technical Specifications
- Contacting Dell
Dell Precision 5510 Owner's Manual
Removing the DC-in Connector
- Follow the procedures in Before Working Inside Your Computer.
- Remove the:
- Perform the following steps to remove the
I/O board:
- Disconnect the DC-in cable from the system board [1].
- Remove the screw that secures the DC-in cable to the computer.
- Remove the DC-in connector from the computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\