Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Aurora R5 Service Manual

PDF

Procedure

  • NOTE: Note the routing of all cables as you remove them so that you can reroute them correctly after you replace the power supply.
  1. Lay the computer on the right side.
  2. Slide the power supply unit release latches towards the top of the computer.
    Image: Sliding the power supply unit release latches
    1. power-supply unit
    2. chassis
    3. power supply unit release latches (2)
  3. Lift the power-supply unit while pressing and holding the graphics-card bracket.
    Image: Rotating the power-supply unit
    1. power-supply unit
    2. graphics-card bracket
    3. chassis
  4. Rotate the power-supply unit away from the chassis.
    Image: Rotating the power-supply unit
    1. power-supply unit
  5. Press the releasing clip on the power-cable connectors and disconnect the power cables from the graphics card.
  6. Disconnect the power cables from the optical drive and hard drives.
  7. Disconnect the processor-power cable and system-board power cable from the system board.
    Image: Disconnecting the cables from the power-supply unit
    1. power-supply unit
    2. hard-drive power cable
    3. graphics-card power cables (2)
    4. releasing clips (2)
    5. hard-drive power cable
    6. processor-power cable
    7. optical-drive power cable
    8. system-board power cable
  8. Rotate the power-supply unit towards the chassis until the unit snaps into place.
  9. Remove the screws that secure the power-supply unit bracket to the power-supply unit.
  10. Lift the power-supply unit bracket off the power-supply unit.
    Image: Removing the power-supply unit bracket
    1. chassis
    2. screws (2)
    3. power-supply unit bracket
    4. power-supply unit
  11. Remove the screws that secure the power-supply unit to the chassis.
  12. Lift the power-supply unit, along with the cables, off the chassis.
    Image: Removing the power-supply unit
    1. chassis
    2. power-supply unit
    3. screws (4)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\