Deploying additional DDVE appliances in the
Cyber Recovery vault
Multiple production
DD systems can replicate data to multiple
DD Virtual Edition (DDVE) appliances in the
Cyber Recovery vault. After the
Cyber Recovery solution is deployed on
Azure, you can add additional DDVE appliances to the
Cyber Recovery vault.
Prerequisites
An additional DDVE is deployed in the
Cyber Recovery vault on
Azure.
Ensure that you:
Follow instructions for deploying a DDVE on
Azure in the
PowerProtect DD Virtual Edition in Azure Installation and Administration Guide at
Dell Online Support.
Configure the newly added DDVE so that it is on the same subnetwork as the existing DDVE.
Configure the newly added DDVE so that it uses the same security group as the existing DDVE.
Create a container in Azure hot blob storage as described in the
PowerProtect DD Virtual Edition in Azure Installation and Administration Guide.
NOTE You cannot access the blob storage on the newly added DDVE until you complete the following steps.
About this task
Perform the following steps to ensure connectivity between the jump host and an additional DDVE in the
Cyber Recovery vault:
Steps
In the Azure portal, search for
Network Security Groups in the search bar.
Click
Network Security Groups.
Find the Network Security Group for the jump host on the deployment.
Edit the security group:
Click the
Outbound security rules tab in the left pane.
Click the
Allow_Jump_Host_to_DDVE_HTTPS_Out rule name.
In the
Destination IP addresses/CIDR ranges field, add the additional DDVE IP addresses as a comma-separated list.
Click
Save.
Return to the
Dell PowerProtect DDVE in the Azure Cloud Installation and Administration Guide instructions to create a file system on Blob Storage on the newly added DDVE.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\