Dell Configuration Guide for the S4048–ON System 9.14.2.5

Using the Private VLAN Commands

To use the PVLAN feature, use the following commands.

• Enable/disable Layer 3 communication between secondary VLANs.
  INTERFACE VLAN mode
  [no] ip local-proxy-arp
  NOTE Even after you disable ip-local-proxy-arp (no ip-local-proxy-arp) in a secondary VLAN, Layer 3 communication may happen between some secondary VLAN hosts, until the address resolution protocol (ARP) timeout happens on those secondary VLAN hosts.
• Set the mode of the selected VLAN to community, isolated, or primary.
  INTERFACE VLAN mode
  [no] private-vlan mode {community | isolated | primary}
• Map secondary VLANs to the selected primary VLAN.
  INTERFACE VLAN mode
  [no] private-vlan mapping secondary-vlan vlan-list
• Display type and status of PVLAN interfaces.
  EXEC mode or EXEC Privilege mode
  show interfaces private-vlan [interface interface]
• Display PVLANs and/or interfaces that are part of a PVLAN.
  EXEC mode or EXEC Privilege mode
  show vlan private-vlan [community | interface | isolated | primary | primary_vlan | interface interface]
• Display primary-secondary VLAN mapping.
  EXEC mode or EXEC Privilege mode
  show vlan private-vlan mapping
• Set the PVLAN mode of the selected port.
  INTERFACE
  switchport mode private-vlan {host | promiscuous | trunk}