Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

debug vrrp

Enable VRRP debugging.

Syntax
debug vrrp [vrrp-id] {all | bfd | database | interface | ipv6 | packets | state | timer}

To disable debugging, use the no debug vrrp [vrrp-id] {all | bfd | database | interface | ipv6 | packets | state | timer} command.

Parameters
vrrp-id
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all
Enter the keyword all to enable debugging of all VRRP groups.
bfd
Enter the keyword bfd to enable debugging of VRRP BFD interactions.
database
Enter the keyword database to enable debugging of configuration changes.
interface
Enter the following keywords and the interface information:
  • For Port Channel interface types, enter the keywords port-channel then the number.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
  • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
  • For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN ID range is from 1 to 4094.
interface
Enter the keyword interface to enable debugging of interface state changes.
ipv6
Enter the keyword ipv6 to enable debugging for IPv6.
packets
Enter the keyword packets to enable debugging of VRRP control packets.
state
Enter the keyword state to enable debugging of VRRP state changes.
timer
Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes
EXEC Privilege
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.5.1.0
Introduced on the C-Series.
6.2.1.1
Introduced on the E-Series.
Usage Information
If you do not specify an option, debug is active on all interfaces and all VRRP groups.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\