Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

To delete an interface, use theno ip http source-interface interface command.

interface

Enter the following keywords and the interface information:

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.10(0.1)

Introduced on the S6010-ON and S4048T-ON.

9.10(0.0)

Introduced on the S3148.

9.10(0.1)

Introduced on the S6010-ON and S4048T-ON.

9.10(0.0)

Introduced on the S6100–ON.

9.8(2.0)

Introduced on the S3100 series.

9.8(1.0)

Introduced on the Z9100–ON.

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.7(0.0)

Introduced on the S6000-ON.

9.3(0.1)

Introduced on the S4810, S4820T, S6000, and Z9000.

8.3.11.1

Introduced on the Z9000

8.2.1.0

Increased number of VLANs to 4094 (was 2094)

8.1.1.0

Introduced on E-Series

7.6.1.0

Support added for S-Series

7.5.1.0

Introduced on C-Series