Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

ip telnet server vrf

Configures the TELNET server on either a specific VRF or a management VRF.

Syntax
ip telnet server vrf {vrf-name | any | management}

To undo the TELNET server configuration, use the no ip telnet server [vrf vrf-name] command.

Parameters
vrf-name
Enter the vrf-name to specify the VRF that is used by the TELNET server.
any
Enter the keyword any to enable server from any VRF.
management
Enter the keyword management to specify a management VRF that is used by the TELNET server.
Defaults
Disabled
Command Modes
CONFIGURATION
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100-ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.0)
Introduced on the Z9500.
9.4.(0.0)
Introduced on the S-Series and Z9000.
Usage Information
You can enable the TELNET server on either a management VRF or a user-defined VRF but not both. If you do not specify a VRF name, then the TELNET server is enabled on the default VRF.
Example
DellEMC(conf)# ip telnet server vrf vrf1 
DellEMC(conf)# no ip telnet server vrf 
DellEMC(conf)# ip telnet server vrf management 
DellEMC(conf)# no ip telnet server vrf 
DellEMC(conf)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\