Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

ipv6 nd reachable-time

Configure the amount of time before an IPv6 neighbor is considered unreachable.

Syntax
ipv6 nd reachable-time reachable-time

To restore to default, use the no ipv6 nd reachable-time command.

Parameters
reachable-time
Enter the reachable time in milliseconds. The value is from 0 to 3600000. The default value is 0.
Default
Disabled
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.12(1.0)
Introduced on the S5048F–ON.
Legacy version
Introduced on the S series and Z series.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\