Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version

Description

9.11(0.0)

Introduced on the C9010.

9.10(0.1)

Introduced on the S6010-ON and S4048T-ON.

9.10(0.0)

Introduced on the S3148.

9.10(0.0)

Introduced on the S6100-ON.

9.9(0.0)

Introduced on the Z9500.

9.8(2.0)

Introduced on the S3100 series.

9.8(1.0)

Introduced on the Z9100-ON.

9.8(0.0P5)

Introduced on the S4048-ON.

9.8(0.0P2)

Introduced on the S3048-ON.

9.7(0.0)

Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, and Z9000 switches.

DellEMC(conf)# ipv6 nd ra-guard policy test
DellEMC(conf-ra_guard_policy_list)#show config
!
ipv6 nd ra-guard policy test
 device-role router
 hop-limit maximum 251
 mtu 1350
 other-config-flag on
 reachable-time 540
 retrans-timer 101
 router-preference maximum medium
 trusted-port
DellEMC(conf-ra_guard_policy_list)#

• ipv6 nd ra-guard enable — configure the RA guard related commands.

• ipv6 nd ra-guard policy — define the RA guard policy name and enter the RA guard policy list configuration mode.

• device-role — specify the role of the device attached to the port.

• hop-limit — enable the verification of the advertised hop count limit.

• mtu — set the maximum transmission unit (MTU) value.

• other-config-flag — enable the verification of the advertised other configuration parameter.

• reachable-time — set the advertised reachability time.

• retrans-timer — set the advertised retransmission time.

• router-preference maximum — enable the verification of the advertised default router preference (DRP) value.

• trusted-port — apply the policy to trusted ports.