Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

storm-control broadcast (Configuration)

Configure the percentage of broadcast traffic allowed in the network.

Syntax
storm-control broadcast [packets_per_second in]

To disable broadcast rate-limiting, use the no storm-control broadcast [packets_per_second in] command.

storm-control broadcast [percentage decimal_value in | out]| [wred-profile name]][packets_per_second in]

To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value in | out] | [wred-profile name]] [packets_per_second in] command.

Parameters
percentagedecimal_value in | out
E-Series Only: Enter the percentage of broadcast traffic allowed in or out of the network. Optionally, you can designate a decimal value percentage, for example, 55.5%. The decimal range is from .1 to .9.
wred-profile name
E-Series Only: Enter the keyword wred-profile followed by the profile name to designate a wred-profile.
packets_per_second in
Enter the packets per second of broadcast traffic allowed into the network. The range is from 0 to 33554368.
Defaults
none
Command Modes
CONFIGURATION (conf)
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.10(0.0)
Introduced on the S6100–ON.
9.8(2.0)
Introduced on the S3100 series.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.2(0.0)
Introduced on the M I/O Aggregator. This command is supported in Programmable-MUX (PMUX) mode only.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
7.4.1.0
E-Series Only: Added the percentage decimal value option.
6.5.1.0
Introduced on the E-Series.
Usage Information
Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is treated as unknown-unicast traffic.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\