Dell Command Line Reference Guide for the S4048–ON System 9.14.2.8

PDF

vrrp bfd neighbor

Establish a BFD for VRRP session with a neighbor.

Syntax
vrrp bfd neighbor ip-address

To remove the BFD session with the neighbor, use the no vrrp bfd neighbor ip-address command.

Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal format (A.B.C.D).
Defaults
None
Command Modes
INTERFACE
Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide.

Version
Description
9.10(0.1)
Introduced on the S6010-ON and S4048T-ON.
9.10(0.0)
Introduced on the S3148.
9.8(2.0)
Introduced on the S3100 series.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.0.0.0
Introduced on the Z9000.
8.3.19.0
Introduced on the S4820T.
8.3.10.0
Introduced on the S4810.
8.2.1.0
Introduced on the E-Series.
7.6.1.0
Introduced on the C-Series.
7.5.1.0
Added support for VLAN and port-channel interfaces on the E-Series.
7.4.1.0
Introduced on the E-Series.
Related Commands
  • show bfd neighbors — display the BFD neighbor information on all interfaces or a specified interface.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\