Installing The
iDRAC Service Module on Linux operating system
The available features that can be installed are displayed on the
screen. The available options are:
[1] Watchdog
Instrumentation Service.
[2] Lifecycle
Log Replication.
[3] Operating
System Information.
[4] iDRAC
access via Host OS
[5] iDRAC
Hard Reset
[6] All features.
To install the required feature, enter the number of the respective
feature.
NOTE: Separate the number of the features to be installed by a comma.
NOTE: To install all
the three features select All features option.
If you do not want to continue the installation, enter q to
quit.
NOTE: Starting iDRAC Service
Module 2.4, you can also modify the features after installation.
NOTE: To know if iDRAC
Service Module is installed on your Linux operating system, run the
command /etc/init.d/dcismeng status. If the iDRAC
Service Module is installed and running, the status running is displayed.
NOTE: Use the systemctl
status dcismeng.service command instead of the init.d command to check if the iDRAC Service Module is installed on RedHat
Enterprise Linux 7 or SUSE Linux Enterprise 12 operating system.
NOTE:
You must provide a unique port number between the range 1024 to 65535
if you chose to install iDRAC access via Host OS feature. If you do
not provide a port number, port number 1266 or a previously
configured port (if any) is assigned by default.
NOTE: if OpenManage Server Administrator (OMSA) is already installed on 1311, the same port could not be utilized for iDRAC Service module.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\