Enabling or
disabling alerts using web interface
To enable
or disable generating alerts:
- In iDRAC web interface, go to .
The Alerts page is displayed.
- Under Alerts section:
- Select Enable to enable alert
generation or perform an event action.
- Select Disable to disable
alert generation or disable an event action.
- Click Apply to save
the setting.
Quick Alert Configuration
To configure alerts in bulk:
- Go to Quick Alert Configuration under Alert Configuration page.
- Under Quick Alert Configuration section:
- Select the alert category.
- Select the issue severity notification.
- Select the location where you would like to receive these notifications.
- Click Apply to save
the setting.
NOTE: You must select at least one category, one severity, and one destination type to apply the configuration.
All the alerts that are configured are displayed in total under Alerts Configuration Summary.
Data is not available for the Topic