Inspiron 14 7430 2-in-1 Owner's Manual

Installing the display assembly

CAUTION: The information in this section is intended for authorized service technicians only.

If you are replacing a component, remove the existing component before performing the installation process.

The following image(s) indicate the location of the display assembly and provides a visual representation of the installation procedure.

Display Assembly Installation

Place the palm-rest and keyboard assembly on a clean and flat surface.
Place the display assembly on the palm-rest and keyboard assembly.
CAUTION: To avoid damaging the display, do not slide the display assembly.
Align the screw holes on the left display hinge with the screw holes on the palm-rest and keyboard assembly.
Replace the two screws (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
Align the screw holes on the right display hinge with the screw holes on the system board.
Replace the three screws (M2.5x4) and the screw (M2x4) that secure the right display hinge to the palm-rest and keyboard assembly.
Close the display lid and place the computer on a clean and flat surface.
Connect the touch-screen cable to the connector on the system board and close the latch.
Connect the display cable to the connector on the system board and close the latch.
Adhere the tape that secures the display-cable connector latch to the system board.