- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of your system
- Base cover
- Battery
- WLAN card
- Memory modules
- Solid-state drive
- Removing the M.2 2280 solid-state drive (SSD-1)
- Installing the M.2 2280 solid-state drive (SSD-1)
- Removing the M.2 2230 solid-state drive (SSD-1)
- Installing the M.2 2230 solid-state drive (SSD-1)
- Replacing the SSD-1 support bracket
- Removing the M.2 2280 solid-state drive (SSD-2)
- Installing the M.2 2280 solid-state drive (SSD-2)
- Speakers
- GPU fan
- System fan
- Heat sink
- Coin-cell battery
- I/O board
- Power button with fingerprint reader (optional)
- DC-in port
- Touchpad
- Display assembly
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 7501 Service Manual
Installing the memory module (single slot)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the memory module and provides a visual representation of the installation procedure.
Steps
- Lift the mylar, and align the notch on the memory module with the tab on the memory-module slot.
- Slide the memory module firmly into the slot at an angle.
- Press the memory module down until it clicks into place.
NOTE If you do not hear the click, remove the memory module and reinstall it.
Next steps
- Install the base cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\