- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of your system
- Base cover
- Battery
- WLAN card
- Memory modules
- Solid-state drive
- Removing the M.2 2280 solid-state drive (SSD-1)
- Installing the M.2 2280 solid-state drive (SSD-1)
- Removing the M.2 2230 solid-state drive (SSD-1)
- Installing the M.2 2230 solid-state drive (SSD-1)
- Replacing the SSD-1 support bracket
- Removing the M.2 2280 solid-state drive (SSD-2)
- Installing the M.2 2280 solid-state drive (SSD-2)
- Speakers
- GPU fan
- System fan
- Heat sink
- Coin-cell battery
- I/O board
- Power button with fingerprint reader (optional)
- DC-in port
- Touchpad
- Display assembly
- System board
- Palm-rest and keyboard assembly
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Inspiron 7501 Service Manual
Removing the display assembly
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the base cover.
- Remove the system fan.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
Steps
- Locate the display cable and display hinges on your computer.
- Peel the tape that secures the display cable to the system board.
- Open the latch, and disconnect the display cable from the system board.
- Remove the two screws (M2.5x5) and (M2.5x4) that secure the left-display hinge to the system board.
- Remove the two screws (M2.5x5) and (M2.5x4) that secure the right-display hinge to the system board.
- Open the display hinges at an angle of 90 degrees.
- Gently slide and remove the palm-rest and keyboard assembly off the display assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\