Dell Latitude 7380 Owner's Manual

Removing display assembly

1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the WLAN card.
4. Remove the WWAN card.
   NOTE To identify the number of screws, see screw list.
5. To remove the display assembly:
   1. Un route the WLAN and WWAN cables from the routing channels [1].
   2. Remove the M2.0 x 5.0 screws that secure the eDP bracket [2].
   3. Lift the eDP bracket from the eDP cable [3].
   4. Disconnect the eDP cable from its connector on the system board [4].
      NOTE In touch-configuration system, you need to remove the touch display cable that is connected to its connector on the system board.
   5. Remove the adhesive tape that secures the eDP cable [5].
      NOTE In touch-configuration system,, you will find both eDP cable and touch display cable that is secured with adhesive tape.
   
6. To remove the display assembly:
   1. Open the display of the computer and lay it on a flat surface at 180 degree angle.
   2. Remove the M2.5 x 4.0 screws (6) that secure the display hinge to the display assembly [1].
   3. Lift the display assembly from the computer [2].