DTK provides WINPE5.x_driverinst.BAT (for Windows PE 5.1),
and WINPE10.x_driverinst.BAT scripts to pre-install the Dell
drivers into a base Windows PE 5.1 and Windows PE 10.0 images. To
execute the script (for example, WINPE10.x_driverinst.BAT)
on 64-bit systems:
NOTE: Make sure that you
have administrator privileges before running the scripts.
At the command prompt, type the following
command to change the directory to the location of the script, WINPE10.x_driverinst.BAT : cd C:\Dell\x64\Drivers\winpe10.x
Execute the script: WINPE10.x_driverinst.BAT
<WIMPATH> <DTKPATH>
where <WIMPATH> is the destination path
to create the directory structure for Windows PE and <DTKPATH> is the path for the Dell drivers in the extracted DTK toolkit.
For example, WINPE10.x_driverinst.BAT C:\winpe_10 C:\DELL\x64\DRIVERS.
This pre-installs the Dell drivers into Windows
PE image. The successful execution of the above commands creates a
bootable ISO image for Windows PE 5.1 and 10.0 at <WIMPATH>.
NOTE: The destination
folder (C:\winpe_10) is created as part of the
process, and must not be an existing directory. The destination path
and the path to the Dell drivers must not contain any blank space.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\