Using the sample
DTK scripts to run a full deployment
A scripted DTK deployment relies on the master deployment
file to integrate all the applicable DTK task scripts and utilities
and perform pre‑operating system configuration tasks before launching
the operating system installation files. The master deployment file,
along with the TKENVSET.BAT (for Windows) or
tkenvset.sh (for Linux) scripts, makes up the
master set of instructions that drives the deployment process. This
file is not provided with the sample scripts.
A sample DEPLOY.BAT is given below:
::
*****************************************************
::Call TKENVSET.BAT to discover platform information
::as well as set paths and environment variables for
::Deployment Toolkit Tools and Scripts.
*****************************************************
*****************************************************
:: call RAIDCFG.BAT to configure RAID.
::
*****************************************************
*****************************************************
:: Replicate the system settings to the current SUT!.
CALL SYSREP.BAT or DTKRUNALL.BAT.
::
*****************************************************
*****************************************************
::Partitioning the system hard disk. call PARTCFG.BAT.
*****************************************************
*****************************************************
:: Put hdd as first in boot sequence (1-removable, 2-
cdrom, 3-hdd)
:: If the system configuration has changed (i.e. a
::boot device was added, removed, or enabled in BIOS)
::the following line should be modified to reflect the
::new hdd device number.
:: This is calling Windows installer scripts.
*****************************************************
::%DT_TOOLS%\syscfg --bootseq=hdd.emb.0
::call WIN2K12.BAT
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\