- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Removing and installing components
- Recommended tools
- Screw size list
- Tower motherboard layout
- Side cover
- Bezel
- Front panel door
- Hard drive assembly—3.5-inch and 2.5-inch
- Removing 3.5–inch hard drive assembly
- Removing 3.5–inch hard drive from the hard drive bracket
- Installing the 3.5–inch hard drive into the hard drive bracket
- Installing 3.5–inch hard drive assembly
- Removing the 2.5–inch hard drive assembly
- Removing the 2.5–inch drive from the drive bracket
- Installing the 2.5–inch hard drive into the hard drive bracket
- Installing the 2.5-inch drive assembly
- Optical drive
- M.2 PCIe SSD
- SD card reader
- Memory module
- Expansion card
- Optional VGA module
- Power supply unit
- Intrusion switch
- Power button
- Speaker
- Coin cell battery
- Heat sink fan
- Heat sink
- Processor
- System fan
- System board
- Troubleshooting
- Getting help
Dell OptiPlex 5060 Tower Service Manual
Installing front bezel
- To install the
front bezel:
- Position the bezel to align the tab holders with the slots on the system chassis.
- Press
the bezel until the tabs click into place.
- Install the Side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\