OptiPlex 7060 Tower Service Manual

Installing system fan

1. Insert the grommets into the slots from the back of the computer.
   NOTE Install the lower two grommets first.
2. Hold the system fan with the cable facing the bottom of the computer.
3. Align the grooves of the system fan with the grommets on the chassis wall.
4. Pass the grommets through the corresponding grooves on the system fan [1].
5. Stretch the grommets and slide the system fan toward the computer until it locks into place [2].
6. Connect the system fan cable to the connector on the system board [3].
   
7. Close the front panel door.
8. Install the:
   1. Intrusion switch
   2. Front bezel
   3. Side cover
9. Follow the procedure in After working inside your computer.