- Notes, cautions, and warnings
- Working on your computer
- Installing the Accessories
- Installing the Power Adapter
- Installing the Dell OptiPlex Micro Dual VESA Mount
- Installing the Dell OptiPlex Micro VESA Mount
- Installing the Dell OptiPlex Micro Vertical Stand
- Installing the Dell OptiPlex Micro Console with DVD-RW
- Installing the Dell OptiPlex Micro All-in-One Mount Behind the Monitor
- List of Compatible Monitor Models
- Disassembly and reassembly
- Front and Back View
- Removing the Cover
- Installing the Cover
- Removing the Processor Fan Module
- Installing the Processor Fan Module
- Removing the Speaker
- Installing the Speaker
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the HDMI or DisplayPort Connector Board
- Installing the HDMI or DisplayPort Connector Board
- Removing the PS2 and Serial Connector Board
- Installing the PS2 and Serial Connector Board
- Removing the Heatsink
- Installing the Heatsink
- Removing the Processor
- Installing the Processor
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the M.2 SSD or DDPE Card
- Installing the M.2 SSD or DDPE Card
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- System Board Layout
- Removing the System Board
- Installing the System Board
- System setup
- Specifications
- Contacting Dell EMC
Dell OptiPlex 9020M Owner's Manual
Installing the Power Adapter
- Perform the following steps as shown in the illustration:
- Slide to open the cover of the power adapter [1].
- Install the power cable to the power adapter and place the power adapter in the box [ 2,3].
- Insert the cable into the box and slide back the cover
to lock it.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\