Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge RAID Controller 9 User’s Guide H330, H730, and H830

PDF

Installing the HBA330 mini monolithic controller

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE:It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
  2. Open the system.
  3. Locate the storage controller card retention hook on the system board and insert the end of the card at an angle into the storage controller retention hook.
    CAUTION:To prevent damage to the card, you must hold the card by its edges only.
  4. Lower the storage controller card to align the screw holes on the card with the screw holes on the connector.
  5. Connect the storage controller cable:
    1. Grasp the cable on both sides of the cable connector and connect to the HBA card.
    2. Tighten the screws to secure the cable and the card to the system board.
  6. Connect the SAS data cable connector to the card.
    NOTE:Ensure that you connect the cable according to the connector labels on the cable. The cable does not function properly if reversed.
  7. Route the SAS data cable through the clip on the card and through the channel on the inner side of the chassis.
  8. Attach the connector labeled "SAS A" to connector SAS A on the backplane, and attach the connector labeled "SAS B" to connector SAS B on the backplane.
  9. Close the system.
  10. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\