Dell PowerEdge RAID Controller 9 User’s Guide H330, H730, and H830

Removing a H730P slim card

1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
   NOTE:It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
2. Open the system.
3. Locate the H730P slim card on the system board.
4. Loosen the two retention screws on the H730P slim card cable connector.
5. Holding the pull tag, lift the H730P slim card cable connector from the system board connector.
6. Press the release latch on the side of the chassis to the unlock position and slide the H730P slim card toward the back of the system.
   CAUTION: To prevent damage to the H730P slim card, you must hold the card only by its edges.
7. Lift the card up and away from the system.
8. Replace the storage controller card and connect the cable. For more information on installing the card, see Installing a H730P Slim card.

   

   1. standoff (2)
   2. H730P slim card cable connector
   3. pull tag
   4. H730P slim card
   5. H730P slim card release latch
   6. lock and unlock icon on the H730P slim card bracket