Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge FC640 Installation and Service Manual

PDF

Removing the system from the enclosure

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.

  2. Turn off the system.

Steps

  1. Press the release button on the system handle to release the handle.
  2. Holding the system handle, slide the system out of the enclosure.
    CAUTION: To protect the I/O connector pins, install the I/O connector cover every time a system is removed from the enclosure.
    Figure 1. Removing the system from the enclosure
    This image shows removing the system from the enclosure.
  3. Install the I/O connector cover over the I/O connector.
    Figure 2. Installing the I/O connector cover
    This image shows installing the I/O connector cover.

Next steps

Install the system or system blank into the enclosure.

CAUTION: If you are permanently removing the system, install a system blank. Operating the enclosure for extended periods of time without a blank installed can cause the enclosure to overheat.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\