Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R340 Installation and Service Manual

PDF

Installing a 2.5 inch drive into the 3.5 inch drive adapter

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. If installed, remove the front bezel.
  3. Remove the drive carrier.

Steps

  1. Align the screw holes on the 2.5-inch drive with the screw holes on the 3.5-inch drive adapter.
  2. Using a Phillips #1 screwdriver, install the screws to secure the drive to the 3.5-inch drive adapter.
    NOTE If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to install the drive to a 3.5-inch drive adapter.
    Torx screw image
    Figure 1. Installing a 2.5-inch drive into the 3.5-inch drive adapter

    This image shows how to install the 2.5-inch drive into the 3.5-inch drive adapter.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\