Dell EMC PowerEdge R340 Installation and Service Manual

Removing the expansion card riser

1. Open the blue expansion card riser retention-latch located on the system.
2. Holding the blue touch points, lift the expansion card riser from the system.

   
   

   

   
   

3. If you are not replacing the expansion card riser, install a expansion card riser filler bracket by performing the following steps:
   1. Align the expansion card riser filler bracket with the slot on the system.
   2. Push the expansion card riser filler bracket downward until firmly seated.
   3. Close the blue expansion card retention latch by pushing the latch down until the latch snaps into place.
   4. Using a Phillips #2 screwdriver, tighten the screw to secure the expansion card riser filler to the chassis.
4. Using a Phillips #2 screwdriver, fasten the screw to secure the expansion card riser filler to the chassis.