Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R440 Installation and Service Manual

PDF

Installing the expansion card into the expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. If installing a new expansion card, unpack it and prepare the card for installation.
    NOTE For instructions, see the documentation accompanying the card.
  3. Remove the expansion card riser.

Steps

  1. Open the PCIe card holder latch.
  2. If installed, remove the filler bracket.
    NOTE Store the filler bracket for future use. Filler brackets must be installed in empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
    Figure 1. Removing filler bracket for riser 2
    This image shows removing filler bracket for riser 2
    Figure 2. Removing filler bracket for riser 1
    This image shows removing filler bracket for riser 1
  3. Hold the card by its edges, and align the card edge connector with the expansion card connector on the riser.
  4. Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
  5. Close the expansion card latch.
    Figure 3. Installing expansion card into riser 2
    This image shows installing expansion card into riser 2
    Figure 4. Installing expansion card into riser 1
    This image shows installing expansion card into riser 1

Next steps

  1. If applicable, connect the cables to the expansion card.
  2. Install the expansion card riser
  3. If applicable, install the air shroud.
  4. Follow the procedure listed in After working inside your system.
  5. Install any device drivers required for the card as described in the documentation for the card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\