Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R530 Owner's Manual

PDF

Installing the hard drive backplane

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Disconnect the data, signal and power cables to the backplane.
  4. Remove all SAS/SATA/SSD hard drives.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Use the hooks on the chassis as guides to align the hard drive backplane to the chassis.
  2. Lower the hard drive backplane until the release tabs snap into place.
  3. Connect the SAS/SATA/SSD data, signal, and power cable(s) to the backplane.
    Figure 1. Installing the hard drive backplane
    This figure shows installing the hard drive backplane.
    1. backplane
    2. release tab (2)
    3. slot on the backplane
    4. hook on the chassis

Next steps

  1. Install all SAS/SATA/SSD hard drives in their original locations.
  2. Reconnect the data, signal and power cables to the backplane.
  3. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\