Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R740xd Installation and Service Manual

PDF

Removing integrated storage controller card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the expansion card riser 1.

Steps

  1. Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the system board.
  2. Lift the integrated storage controller cable away from the integrated storage controller.
    Figure 1. Removing integrated storage controller cable
    This image shows removing integrated storage controller cable.
  3. Lift one end of the card and angle it to disengage the card from the integrated storage controller card holder on the system board.
  4. Lift the card out of the system.
  5. Hold the interposer board by its edges, and pull the board until the connector on the board disengages from the connector on the system board.
    Figure 2. Removing integrated storage controller card
    This image shows removing the integrated storage controller card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\