Using autocomplete feature
Use the autocomplete feature in firmware RACADM to:
- Display all the available RACADM commands in the alphabetical order by pressing the tab key at the
racadm>> prompt.
- View the complete list, by entering the starting letter of the command at the
racadm>> prompt and press tab key.
NOTE:
- Commands that are displayed/suggested by the shell are case insensitive.
- If an attribute group does not include any attributes, autocomplete does not display this group at all.
- Navigate the cursor within a command, by pressing:
- Home key: Directs to the starting of the command
- End key: Directs to the end of the command
- View the history of the commands that were run in the current session by pressing up and down arrow key.
- If an attribute value starts with double quotes but does not end with them, the value is still considered and the command runs successfully.
- Exit the Autocomplete mode, by entering
Quit or
Exit
For example:
- Example 1:
racadm>> <press tab>
arp
autoupdatescheduler
clearasrscreen
clearpending
closessn
clrraclog
.
.
.
.
.
.
.
vflashsd
vflashpartition
vmdisconnect
cd
quit
- Example 2: racadm>> get <press tab>
get
getled
getniccfg
getraclog
getractime
getsel
getsensorinfo
getssninfo
getsvctag
getsysinfo
gettracelog
getversion
- Example 3:
racadm>> getl<press tab>
racadm>> getled <press enter> or <racadm getled>
LEDState: Not-Blinking
- Example 4:
racadm>> get bios.uefiBootSettings
BIOS.UefiBootSettings
BIOS.UefiBootSettings.UefiBootSeq
BIOS.UefiBootSettings.UefiPxeIpVersion
NOTE:
- In the RACADM autocomplete mode, type the commands directly without giving racadm as prefix.
- NIC/FC/InfiniBand FQDDs are configuration-dependent. To find FQDDs present in system, run the RACADM command
racadm hwinventory NIC/FC/InfiniBand
Data is not available for the Topic