Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge RAID Controller 9 User’s Guide H330, H730, and H830

PDF

Removing the PERC FD33xD Card

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
NOTE:PERC FD33xS and FD33xD cards are supported only on PowerEdge FD332 system. The procedure for removing a PERC FD33xS card is identical to removing a PERC FD33xD card.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  2. Open the system.
  3. Locate the PERC card.
  4. Loosen the screws securing the cable to the PERC card.
  5. Lift the cable away from the PERC card by holding the cable touch point.
  6. Holding the touch point, allow the cable to slowly retract into the cable coil.
  7. Remove the screws securing the PERC card to the PERC card holder.
  8. Holding it by the touch points, lift the PERC card from the connector on the midplane interface module.
    Figure 1. Removing and installing the PERC FD33xD card
    This figure shows removing and installing the PERC FD33xD card.
    1. PERC FD33xD card
    2. screw (3)
    3. touch point on the cable
    4. cable screw (2)
    5. touch point on the PERC card (4)
    6. connector on midplane interface module
  9. Close the system.
  10. Reconnect the system to its electrical outlet and turn on the system, including any attached peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\