Near Field Communication using the QuickSync feature
Using the QuickSync feature, you can:
View basic server information such as Service Tag, MAC address, NIC data, firmware versions, operating system, and so on.
View log and monitoring information of a server.
Configure network parameters of a server.
After viewing or editing the information, you can troubleshoot or configure using a mobile device. To use this feature, you must install the OpenManage Mobile (OMM) software application on your mobile device and enable the bezel on the server. The QuickSync feature enables your mobile device to act as a proximity reader which reads data on the server when held at a distance of less than 20 mm from the server front panel. You can perform most of the tasks that you complete by using an LCD panel. The system information is the basic hardware inventory information retrieved from NFC. The attributes allow you to set the access, check the presence of QuickSync feature, enable or disable the Inactivity Timer, set the inactivity timeout value.
NOTE:This feature is supported only on Android mobile devices.
For more information on the QuickSync feature, see the
System QuickSync profile document available at
www.dell.com/whitepapers. Also, see
iDRAC User’s Guide available at
www.dell.com/idracmanuals.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\