Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge T330 Owner's Manual

Removing the control panel board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Phillips #2 screwdriver ready.
  3. Follow the procedure listed in the Before working inside your system section.
  4. Remove the control panel assembly.
  5. Remove the control panel assembly cover.

Steps

  1. Remove the screws that secure the control panel board to the control panel.
  2. Lift the control panel board until the control panel board disengages from the slots on the control panel.
  3. Slide the control panel board toward the back of the control panel, and lift the control panel board away from the control panel.
    Figure 1. Removing the control panel board for systems with hot swappable hard drives
    This figure shows removing the control panel board for systems with hot swappable hard drives.
    1. control panel board
    2. screw (3)

Next steps

  1. Install the control panel board.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\